| نویسندگان | فرهاد جهان تیغ,سیدمحمدباقر قریشی,امیر بیات |
| نشریه | DYES PIGMENTS |
| شماره صفحات | 108 |
| شماره مجلد | 175 |
| ضریب تاثیر (IF) | ثبت نشده |
| نوع مقاله | Full Paper |
| تاریخ انتشار | 2019-12-10 |
| رتبه نشریه | علمی - پژوهشی |
| نوع نشریه | الکترونیکی |
| کشور محل چاپ | ایران |
| نمایه نشریه | JCR |
چکیده مقاله
Single layer graphene quantum dots (SLGQDs, average size of ∼ 9 nm) were added
into N719/TiO2 nanoparticles photoanode (prepared using a doctor blade method) as cosensitizer
and photovoltaic properties were investigated for dye sensitized solar cell (DSSC)
application. Low-cost and high-yield SLGQDs solution was synthesized with only glucose
and DI water as precursor using a hydrothermal method. This method allows the tuning of
optical properties and energy states by using appropriate precursors and synthesis conditions.
Optical characterization reveals that the SLGQDs solution absorbs UV and visible light
photons with wavelengths up to ∼ 700 nm. For engineering a suitable energy state, and then
to obtain an efficient DSSC, lowest unoccupied molecular orbital (LUMO) and highest
occupied molecular orbital (HOMO) of the SLGQDs were determined against vacuum
energy level by utilizing a cyclic voltammetry measurement. Electrical measurements
indicated an improvement in power conversion efficiency for the DSSC fabricated based on
SLGQDs and N719 as co-sensitizers. The experimental analysis shows that this improvement
arises from enhancement of charge collection and separation due to the cascaded alignment
of the energy levels between N719/SLGQDs/TiO2 interfaces. By addition of SLGQDs into
N719/TiO2 nanoparticles photoanode, we were able to increase the short circuit current
density and efficiency by 39% (from 14.47 to 20.03 mA/cm2) and 35% (from 6.57% to
8.92%), respectively.